Our product include 2 parts : sensitive heart rate & breath rate sensor,base station(with camera and circuit)
The Sensor will be placed an infant's bed not too far away from the baby. It will be cordless and battery operated. This sensor will connect to the base station via WiFi or Bluetooth. Since the sensor will be place on the bed with baby, we are looking for a sleek and elegant design.
- Size: The sensor should be at least 3 inch long, 2 inch wide and 1 inch thick.
The sensor shape should be smooth and without any sharp edges. It must have a flat bottom that makes sure the sensor can not roll over easily and more importantly for the sensor to work.
A parent should be able to tell which direction to align the baby and the sensor to maximize sensor readings. However, it should not have any sharp edges in the event that an infant may pick it up and drop it on itself. An elliptical shape is one example of design direction to define a friendly shape.
If the infant is strong enough to lift the sensor, consideration should also be put into the event that they might bite on it. Safe materials especially for infants teething must be a consideration for infant safety.
- Alarm reset button and light
The sensor should have a button on top of it to reset the alarm. This button should be big enough so that parents can reset the alarm easily even while they are holding baby. The sensor should also be lit when the alarm is on and be able to be spotted easily in dim light.
- Rechargeable Battery
An extra battery will be provided for parents. This battery can be a slot where a generic battery can be slotted in or it can be part of a molded part of the design. Changing the battery with ease is especially important. As well as charging the battery.
This base station should be AC power wire connected. The base station will be placed near by the sleeping bed so that the camera will continue monitoring the baby. It will have a ‘I’m keeping watch on you’ aura on its design.
The size of the base station will be close to those regular IP camera sold on the market.
It will have following features;
- Camera with night vision LED
- Small Speaker
- SD card slot
- Battery recharge slot
This battery slot should be same as the battery slot on sensor.
- clip and sit design
The design of base station should also allow for it to be clipped to an edge or a wall for vantage view and also be allowed to rest on a flat top.